I am going to add the vectors for the diamonds that are around the center stone. These diamonds are 1.3mm each. I "Paste Along Curve" 24 of these stones. I selected 24 by trial and error because of the fit. Remember it is best to use an even stone number to paste. I will then add the .6mm diameter prongs by nudging and mirroring them. I like to raise the prongs at a 50 to 80 degree dome and .6mm height. I used 50 degree in this project. This is what the vectors should look like.
The Finished Top
The Top Diamonds Video
No comments:
Post a Comment